Brother MFC-J2310 Service Manual

3-87
Confidential
Assembling Note: Mount the head/carriage unit, using the following steps.
1) When mounting a new head/carriage unit, apply lubricant to the unit, as specified in Section
5 of this chapter.
2) When mounting the CR timing belt, insert it into the head/carriage unit so that the toothed
side faces inwards as shown below and make sure that the upper and lower edges of the belt
are fitted in the latches.
Latches
(3_132_E)

Brother MFC-J2310 Specifications

General

Brand	Brother
Model	MFC-J2310
Category	All in One Printer
Language	English