OK
Click to start uploading data to the machine, and then exit the Remote Setup Program. If an error message
appears, confirm that your data is correct, and then click OK.
Cancel
Click to exit the Remote Setup Program without uploading data to the machine.
Apply
Click to upload data to the machine without exiting the Remote Setup Program.
5. Click OK.
• If your computer is protected by a firewall and is unable to use Remote Setup, you may need to configure the
firewall settings to allow communication through port numbers 137 and 161.
• If you are using Windows
®
Firewall and you installed the Brother software and drivers from the CD-ROM, the
necessary firewall settings have already been set.
Related Information
• ControlCenter4 (Windows
®
)
• Remote Setup (Windows
®
)
440
To Next Page
Loading...
