Home > Paper Handling > Load Documents > Load Documents in the Automatic Document Feeder (ADF)
Load Documents in the Automatic Document Feeder (ADF)
The ADF can hold up 20 pages and feeds each sheet individually.
(Documents that are longer than 11.7 in. (297 mm) must be fed one page at a time.)
Use paper that is within the sizes and weights shown in the table. Always fan the pages before placing them in
the ADF.
Document Sizes and Weights
Length:
5.8 to 14 in. (148 to 355.6 mm)
Width: 5.8 to 8.5 in. (148 to 215.9 mm)
Paper Weight: 17 to 24 lb (64 to 90 g/m²)
IMPORTANT
• DO NOT pull on the document while it is feeding.
• DO NOT use paper that is curled, wrinkled, folded, ripped, stapled, paper clipped, pasted or taped.
• DO NOT use cardboard, newspaper or fabric.
• Make sure documents with correction fluid or written in ink are completely dry.
1. Lift up and unfold the ADF document support (1).
2. Fan the pages well.
3. Adjust the paper guides (1) to fit the width of your document.
4. Place your document, face down, top edge first in the ADF underneath the paper guides until you feel the
document touch the feed rollers and the LCD displays [ADF Ready.].
IMPORTANT
DO NOT leave any documents on the scanner glass. If you do this, the ADF may jam.
Related Information
• Load Documents
65
To Next Page
Loading...
Need help?
General
