5. Gently adjust the paper width guides (1) to fit the paper. Make sure the paper width guides touch the edges of
the paper and the paper is flat in the tray.
6. Slowly push the paper tray completely into the machine.
Do not open the paper support and the paper support flap when using the photo bypass tray. Otherwise it is
difficult to take out the printouts.
IMPORTANT
When you have finished printing photos, return the photo bypass tray to the Normal printing position. If
you do not, you will get a [No Paper Fed] error when you use cut sheet paper.
Photo Bypass Tray in the Normal printing position
Photo Bypass Tray in the Photo printing position
Related Information
• Load Paper
• Error and Maintenance Messages
44
To Next Page
Loading...
