Requirement
– Automatic water supply
– Installation of the automatic flushing device is car-
ried out exclusively by the manufacturer. A con-
nection to a local water supply system may only be
carried out by an authorized plumber.
The automatic flushing device is used to exchange, in regular inter-
vals, the residual water in the water tank and to top it off with fresh
water. This unit is only used in combination with the automatic
water supply; no manual water exchange is required.
The water exchange can be started manually. To do so, proceed
as follows:
Personnel:
n
Operator
To start the flushing device manually via the remote control,
press the [Flush] button.
In addition to the manual start, the flushing device can be pro-
grammed so that the water is automatically exchanged in intervals
of 1–7 days. To do so, proceed as follows:
Personnel:
n
Operator
1. To program the flushing device, open the menu by pressing
the [Prog] button.
2.
Open menu item 31 (
Ä
Chapter 5.6 “Changing the menu set-
tings” on page 35).
3. Change the value according to the desired interval (1–7
days).
4. Once the change has been carried out, wait 10 seconds.
ð
The display read-out jumps back to the default state (dis-
play of the actual humidity value). The changes have
been saved.
The following information is directed exclusively to
licensed plumbers who connect the humidifier to the
local water supply system.
Operation
Information for licensed plumbers
Accessories
Evaporation Humidifier B500 Professional62
To Next Page
Loading...
