The external water monitor can be used as an additional safety
device on humidifiers with an automatic water supply. Unlike the
water safety sensor, the water monitor is equipped with an inde-
pendent solenoid valve, which is connected between the safety
pressure hose and water tap.
The sensor of the water monitor is located in the safety collecting
basin and shuts off the water supply to the humidifier when it
comes into contact with water. In addition, a signal tone sounds
that can only be deactivated by disconnecting the power supply.
8.10 Safety pressure hose
8.10.1 Overview
Order number: 1754
Requirement
ā Automatic water supply
The safety pressure hose secures the connection between the
humidifier and water tap. If leakage occurs on the hose, this is
detected by a safety fabric within the hose and the water supply is
automatically stopped.
8.10.2 Replacing the safety pressure hose
Proceed as follows to replace the safety pressure hose:
Fig. 78: External water sensor
Fig. 79: Safety pressure hose
Accessories
Evaporation Humidifier B500 Professional74
To Next Page
Loading...
