Brune B500 - Changing the Menu Settings

Press the "-" area of the [Fan] rocker switch until the last bar
on the [Fan speed level indicator] is no longer lit.
ð
The [Automatic fan indicator] lights up and the fan is now
in automatic mode.
5.6 Changing the menu settings
The device offers the possibility to deviate from the factory settings
and to make various settings as desired. The menu is visually rep-
resented using numbers in the control panel display. The meaning
of each number is shown in the table Ä on page 36.
Proceed as follows to change the menu settings:
Personnel:
n
Operator
1. On the remote control, press the [Prog] button.
ð
The number 10 appears on the control panel display
(substituting the "Set signal tone" menu).
2. Press the [Prog] button until you reach the desired main
menu.
3. Once the desired main menu lights up on the display, use the
[Set] button to select the desired sub-menu.
ð
After a few seconds, the value (e.g. 00 or 01) of the set-
ting appears on the display.
4. Using the [Humidity] rocker switch, increase ("+" area) or
decrease ("-" area) the value.
5. Once the change has been carried out, wait 10 seconds.
ð
The display read-out jumps back to the default state (dis-
play of the actual humidity value). The changes have
been saved.
If no further settings are carried out within 10 seconds,
the read-out on the display automatically returns to the
default display mode (display of the actual humidity
value). The programming process can be cancelled at
any time by pressing the [ON/OFF] button. In this
case, the performed changes are lost.
Operating the humidifier
Evaporation Humidifier B500 Professional 35