BST ekr CON 600 net User Manual

Commissioning
6
ekr CON 600, ekr CON 600 net – Master-Slave Guiding with Sensor Positioner 19/47
6 Commissioning
This manual only describes the steps that are required to commis-
sion the Master-Slave Guiding with Sensor Positioner on the ekr
CON 600, ekr CON 600 net controller. Any further necessary com-
missioning work is described in the installation and commissioning
manual for the ekr CON 600, ekr CON 600 net controller (docu-
ment number MD.541).
6.1 Safety Instructions
WARNING
Danger of death and material damage caused by incorrect com-
missioning!
►
Have the commissioning carried out by BST service personnel or
authorized personnel only.
DANGER
Danger of death caused by the machine starting up!
Parts of your body could be crushed, cut, drawn in or hit.
►
Switch off the machine completely and secure it against it being
switched back on.
WARNING
Danger of crushing due to motor-driven movement of the sensor
slides!
Body parts could be crushed, sheared or impacted.
►
Never reach into the positioning range of the sensor slides.
►
Prior to set-up/operation, ensure that no persons are in the
positioning range of the sensor slides.
There is a danger of crushing during the sensor slide movement, in
particular when reaching into the hazard zones identified below.
Fig.9: Hazard zones

BST ekr CON 600 net Specifications

General

Brand	BST
Model	ekr CON 600 net
Category	Controller
Language	English