btsr SMART MATRIX MTC - Errors Shown on Display of SM-DIN Boards

Errors shown on Display of SM-DIN Boards
SMART MATRIX MTC 2 - 52
Errors shown on Display of SM-DIN Boards
The failures/errors on SM-DIN Boards are indicated by the following codes on the Board’s display:
RAM Error
Error detected on RAM memory contents; the memory will be initialized with the default values.
EEPROM Error
Error detected on EEPROM memory contents; the memory will be initialized with the default values.
One or more MTC sensors connected to the board require a firmware upgrade.
One or more MTC sensors in “BROKE” alarm (broken yarn)
One or more MTC sensors in “BLIND” alarm (too much room light)
One or more MTC sensors in “DIRTY” alarm (dust accumulation)
One or more MTC sensors in “SHORT” alarm (stop output short circuit)
One or more MTC sensors in target
One or more MTC sensors in communication error