Buchi ProxiMate - Ending Measurement; Shutting down the Instrument

6 | Operation BÜCHI Labortechnik AG
70/94 Operation Manual ProxiMate™
u Tap the application you wish to use.
ð The display highlights the application in green.
u Tap the function [Select] on the function bar.
ð The display changes to the [Start] menu.
u According to the application requirements put the sample in the sample presenta-
tion area.
u Tap the [Control] button.
ð The instrument is carrying out the measurement.
ð The status bar shows the status Measuring.
6.15.3 Ending measurement
Precondition:
R The control button shows one of the status measurement finished.
u The symbol of the control button shows in which specifications category the sam-
ple fits.
The following specifications categories are possible:
Specifications cate-
gories
Explanation see Chap-
ter "Control button",
page30
Explanation see Chap-
ter10.1 "Measurement
results", page89
Within specification x x
Tolerence x x
Limit x x
u Continue according to the specification the sample is in.
Within specification Tolerence Limit
u Tap the function [Con-
firm] on the function
bar.
ð The measurement
is saved.
u Tap the control button
u Tap the function [Con-
firm] on the function
bar.
ð The measurement
saved.
u Tap the control button
u Tap the function [Con-
firm] on the function
bar.
ð The measurement
saved.
6.15.4 Shutting down the instrument
Navigation path
➔
u Navigate to the [Start] menu via the navigation path.
u Tap the function [Switch off] on the function bar.
u Answer YES to the confirmation question.
ð The instrument is shutting down.