Buderus RC35 Installation And Servicing Instructions

Operating basics
4
RC35 programming unit - Technical specifications are subject to change without prior notice.
15
4. Press to confirm the selection.
The SERVICE\SETTINGS menu is opened.
5. Turn the rotary selector anti-clockwise until boiler data
is selected (marked with
B).
Press to select boiler data.
6. To change the value, hold down the button (the value
starts flashing) and turn the rotary selector at the same
time.
7. Release the button .
The value stops flashing. The modified value is saved.
8. If you have carried out this example as practice only, make
sure that the original setting is retained.
To do so, repeat steps 6 and 7 if necessary.
9. Press to go back one step.
-or-
To finish entering settings, press several times or shut
the flap.
The default display re-appears.
You can enter all settings in the SERVICE MENU using this procedure.
Operation Result
Table 3 How to use the Service menu (example)
SERVICE\SETTINGS
B plant data
boiler data
domestic hot water
heating circuit 1
SETTINGS\BOILER
What type of building
do you have?
medium
SETTINGS\BOILER
What type of building
do you have?
medium
SETTINGS\BOILER
What type of building
do you have?
light
SETTINGS\BOILER
What type of building
do you have?
medium

Buderus RC35 Specifications

General

Display	LCD
Temperature Control	Yes
Weather Compensation	Yes
Communication	EMS Bus
Mounting	Wall-mounted
Voltage	24 V
Temperature range	5°C to 30°C
Accuracy	±0.5°C
Protection class	IP20
Weight	0.3 kg
Power consumption	2 W
Switching current	Not applicable
Ambient temperature	0°C to 45°C