Diagnosis
7
RC35 programming unit - Technical specifications are subject to change without prior notice.
41
7.2 Monitor value
Use the Monitor value menu to view the target and actual values for the heating system.
The target value will be displayed first and then the actual value. The values displayed for
monitoring purposes vary depending on the system installed.
Be mindful of the information which appears on the display when you switch to
menus or when you enter settings. Press any of the buttons or turn the rotary
selector to confirm the information message.
No settings will be allowed which might result in damage to the components.
This is why some settings may not be accepted.
If the values to be displayed do not all fit on the screen, they are displayed as a
list. The list can be scrolled by turning the rotary selector.
DIAGNOSE \ MON.
VALUE Other information
Boiler / burner The values monitored are displayed as a list; in other words, more val-
ues might appear if the rotary selector is turned.
Hydraulic separator
1)
1) Not possible or not available for boilers with UBA1.x and DBA.
Domestic hot water
(DHW)
Heating circuit 1 Values for other heating circuits are displayed if such circuits are
installed.
Solar
1)
Module UM10
1)
For solid fuel boilers; EV2 = external locking (input)
Wireless transm.
1)
FB = strength of the wireless signal
Bus users
1)
Table 17 Navigator for the Monitor value menu