Buffalo LinkStation 210D - Changing the RAID Mode

41
Chapter 4 Storage Management
1 From Advanced Settings, click [Drives].
2 Click to the right of “RAID”.
3 Click the array to delete.
4 Click [Delete RAID Array].
5 The “Confirm Operation” screen will open. Enter the confirmation number, then click [OK].
6 Click [OK] when completed. Next, create a shared folder by referring to the “Adding a Shared Folder” section in
chapter 3.
Changing the RAID Mode
To change the RAID mode, first put the drives into JBOD by referring to the “Using JBOD” section above. Then, follow
the procedure below.
1 From Advanced Settings, click [Drives].
2 Click to the right of “RAID”.