Buffalo LinkStation 210D - Chapter 5 Remote Access; WebAccess; Configuring from Easy Admin

56
Chapter 4 Storage Management
Using RAID 1
1 From Advanced Settings, navigate to [Drives] > [RAID].
2 Click the RAID array that held the failed drive.
3 Select the replaced drive and click [Recover RAID Array].
4 Enter the confirmation number, then click [OK].
Using RAID 0
1 From Advanced Settings, navigate to [Drives] > [RAID].
2 Click the RAID array that held the failed drive and click [Delete RAID Array].
3 The “Confirm Operation” screen will open. Enter the confirmation number, then click [OK].
4 From [Drives] > [Drives], select the replaced drive and click [Format Disk].
5 The “Confirm Operation” screen will open. Enter the confirmation number, then click [OK].
6 From [Drives] > [RAID], choose “RAID 0” from the RAID mode drop-down list and click [Create RAID Array].
7 The “Confirm Operation” screen will open. Enter the confirmation number, then click [OK].
8 Click [OK] when completed.
The new RAID 0 array will be created. Next, create a shared folder by referring to the “Adding a Shared Folder”
section in chapter 3.
Using JBOD
1 From Advanced Settings, navigate to [Drives] > [Drives].
2 Select the replaced drive and click [Format Disk].
3 The “Confirm Operation” screen will open. Enter the confirmation number, then click [OK].
The drive will be formatted. Next, create a shared folder by referring to the “Adding a Shared Folder” section in
chapter 3.