Bukh D4 - Calibration and Settings Menu

Information Beep
InfoBeep is an audible signal that sounds when there
is a message from the system.
1 Navigate to
Information Beep in the settings
menu.
2
Press
to switch the audible signal on or off.
If there is a tachometer (accessory) installed, the
volume can be adjusted with the aid of .
Press
to confirm the selection. The setting is
confirmed by an audible signal at the set level.
The screen will return automatically to the settings
menu.
Trip Reset
1
Navigate to Trip Reset in the settings menu.
2
Press twice to zero the trip information.
Depth Alarm
Setting the level for the depth alarm on Bukh echo
sounders.
The setting need only be made at one helm station.
1 Navigate to Depth Alarm in the settings menu.
Press to proceed to the submenu.
2
Depth Alarm Off/On (A). Press to switch the
alarm on or off.
3
Proceed to Set Level (B) and press .
Use to set the limit where the alarm must
begin sounding. Press
to confirm the setting.
The depth alarm is dependent on depth
compensation; refer to the next section.
Information Beep
P0012516
Trip Reset
Depth Alarm Level
Calibration and Settings
112 47708085 11-2016 © Bukh