IMPORTANT:
Always change a belt which looks worn or cracked.
Adjusting/replacement of drive belts
The
standard alternator and water pump are driven by
a poly-V belt for the best function and lifespan.
Replace/tension the belt as follows:
1 Loosen the screws (1) on the tension roller bracket.
Remove and replace the belt as required.
2 Tension the belt by applying a torque to the
tensioning roller square fitting (2) of 70 Nm (52
lbf.ft). Lock the tensioning roller using screws (1).
The screws must be tightened to 50 Nm (37 lbf.ft).
3 Repeat the procedure when the engine is warm:
Loosen screws (1) and tension the belt.
Lubrication System
Oil change intervals can vary depending on oil grade
and sulphur content of the fuel, please refer to
Technical Data, page 129.
Oil change intervals must never exceed a period of 12
months.
If you want longer oil change intervals than stated in
the table Technical Data, page 129, the condition of
the oil must be checked by the oil manufacturers
through regular oil testing.
Maintenance
47708085 11-2016 © Bukh 93
To Next Page
Loading...
