3.1.3.1 Bluetooth handset
Repeat the magnetic procedure (step 1) for each new function you wish to lock; no more
than one function can be locked at a time.
•
Only care staff are authorised to use the locking function!
•
If the clinical state of the resident is so critical that any adjustment using the handset pla-
ces him/her at risk, then carers must lock this adjustment function immediately. The care
bed remains in the position it was in at the time it was switched off.
A magnetic sensor is located in the lower area of the handset, see chapter Part C: Bluetooth
Handset » 10.
A loose magnet (supplied) is required to lock or unlock functions.
The magnet supplied must be held right against the magnetic sensor integrated in the hand-
set. The function can then be locked or unlocked.
Proceed as follows to lock/unlock settings on the handset:
1.
Hold the magnet [a] supplied against the magnetic sensor integrated in the handset
(see fig.).
2.
Then lock/unlock the desired function.
•
To lock, press the right button on the handset. To unlock, press the left button
(see following table).
Unlock Function Lock
Backrest
Operation
12 Part C: Care staff and residents
To Next Page
Loading...
