11 Appendix
11.1 Accessories
WARNING
11.1.1 Mattress requirements
The bed must only be operated with original BURMEIER accessories. BURMEIER does not
accept any responsibility for accidents, defects and hazards that arise from the use of other
accessories.
Risk of hazard for residents due to improper use of accessories
Pay attention to the following information when using safety sides, infusion stands, etc. on
electrically adjustable beds: Make sure that the arrangement of accessories does not pro-
duce any crush or shearing zones for the resident when the back and leg rests are adjus-
ted. If this cannot be guaranteed, care staff must safely prevent the resident from adjusting
the back and leg rests.
•
Lock the handset adjustment options in such cases.
Basic dimensions:
Length x width 200 x 90 cm
Thickness/height 10 - 15 cm
Foam rubber density min. 38 kg/m
3
Compression hardness min. 4.2 kPa
Applicable standards: DIN 13014
DIN 597 Part 1 and 2
50 Part B: Operator and Technical Personnel
To Next Page
Loading...
