4.5.11 Information on electromagnetic compatibility (EMC)
ATTENTION
To ensure electromagnetically interference-free operation, only use cables and accesso-
ries that are approved by the manufacturer (see also the chapter “Replacement Parts;
Accessories” in the instruction manual for the bed).
For the intended use as described in the main instruction manual, no significant perform-
ance limitations of this bed are known/expected as a result of possible electromagnetic
interference from neighbouring devices.
Risk of malfunctions
Failure to heed this warning may result in malfunctions and material damage.
•
The use of accessories, transducers and cables other than those supplied by BURMEIER
for this bed may result in increased electromagnetic emissions or reduced electromagnet-
ic immunity of the bed and may lead to incorrect operation.
•
The use of this device next to other devices should be avoided, as this could result in in-
correct operation. If such use is nevertheless necessary, this device and the other devices
should be monitored to ensure that they are working properly.
•
Portable RF communication devices (radio, mobile phones etc.), including their accesso-
ries (such as antenna cables and external antennas) should not be used at a distance of
less than 30 cm from the electrical parts and cables of this bed. Failure to observe this
may result in a reduction in the performance of the device.
The bed is intended for use in the electromagnetic environment described below. The opera-
tor or user of the bed must ensure that it is used in such an environment.
This device is compliant with the following EMC standards regarding interference
emissions and immunity:
Ambient limit values of the interference emissions
Phenomenon Home healthcare environment
Conducted and radiated interference emissions CISPR 11
Harmonic distortions See IEC 61000-3-2
Voltage fluctuations and flicker See IEC 61000-3-3
Product Description
20 Part A: General Information
To Next Page
Loading...
