7.3 Replacing the Bluetooth Handset
7.4 Changing battery of Bluetooth handset
WARNING
First remove the magnets from the handset to avoid any malfunction.
Pairing the new handset causes the old handset to be automatically decoupled from the
control unit.
When inserting the plug, make sure that the recess is pointing upwards. Make
sure that the O-ring seal on the plug is not damaged; otherwise, this plug connec-
tion will not be protected from moisture.
6. Close the cover of the control unit.
• Make sure that the securing clips are fully engaged.
7. Route the cable of the new handset in such a way that it cannot be damaged by any
moving parts of the bed.
8. After replacing the handset with a new one, test that the motorised adjustments are
working!
• Replacing the old handset with the new one.
• After replacing the Bluetooth handset, it must first be paired with the bed control.
See
Part B: Pairing the Bluetooth Handset » 25.
• After replacing the handset with a new one, test that the motorised adjustments are
working!
Battery risk
Failure to follow this can lead to serious injuries.
The batteries in the Bluetooth handset are a risk to babies and small children because they
can be swallowed.
Replacement of Electrical Components
Part B: Operator and Technical Personnel 43
To Next Page
Loading...
