3.6.2 Adjusting the Grab Handle
→
→
3.7 Safety side
The maximum loading capacity at the front end of the lifting pole is 75 kg.
Due to its adjustable belt, the grab handle height can be adjusted to between about 55 cm
and 70 cm (measured from the upper edge of the mattress).
Part C: Image3:
Adjusting the Lifting Pole
Slide the fixed loop of the grab handle over the first bolt on the lifting pole.
Check the secure position of the grab handle by tugging hard on it.
•
The height of the triangular grab handle can be adjusted using the strap.
•
Make sure that the strap is correctly threaded through the buckle.
•
Make sure that the end of the strap projects at least 3 cm from the buckle [f].
Safety sides provide suitable protection for residents against unintentionally falling out of
bed. They are not intended as a device to prevent the resident from intentionally leaving the
bed.
If not used properly, there is a considerable danger of strangulation for the resident! Be sure
to observe the following safety information:
Operation
Part C: Care staff and residents 21
To Next Page
Loading...
