burmeier Dali - Mains Cable Holder

ATTENTION
3.4 Mains Cable Holder
Material damage
Failure to heed this warning may result in damage to the bed and to its surroundings.
•
Only move the bed around if the mattress base in adjusted to its lowest position.
•
Before moving the bed, always ensure that the switch mode power supply is placed safely
on the bed to prevent it from falling off.
•
Before moving the bed around, always ensure that all the castor brakes have been re-
leased. This prevents excessive wear of the castor treads and scuffing marks on the floor.
•
Make sure that the cable of the mains plug/switch mode power supply cannot be stretch-
ed, rolled over or otherwise damaged when moving the bed.
•
Check that all cables, tubes or leads belonging to any accessory devices that are attach-
ed to the bed are safely secured and cannot be damaged.
The bed stands on four steerable castors which are all fitted with a locking brake.
Brake:Press the brake pedal [18] down with your foot.
Move:Lift the brake pedal [18] with your foot.
The power pack cable is fitted with a mains cable holder. The holder is located on the mains
cable itself.
Operation
Part C: Care staff and residents 17