burmeier Dali - Dismantling the Mattress Base Frame; Mount the Dismantled Bed on the Storage Aid

9.2 Dismantling the Mattress Base Frame
9.3 Mount the dismantled bed on the storage aid
7. In the case of econ, low-econ, low-entry-econ: Unscrew the power cable.
8. Unplug the strain relief and plugs from the drive motors of the foot end and head end of
the chassis.
9. Loosen the knurled-thumb screws on the mattress base frame at the foot end to re-
move the chassis foot section; turn the loosened knurled-thumb screws into the storage
aid.
10. Loosen the knurled-thumb screws on the mattress base frame at the head end to re-
move the chassis head section; turn the loosened knurled-thumb screws into the stor-
age aid.
Proceed as follows:
1.
Place the mattress base frame upright against a wall, head end facing down.
2.
Remove the locking pin from the lifting bar of the drive motor for the thigh rest.
3.
Loosen the knurled-thumb screws at the two connection points of the mattress base
frame.
4.
Pull the frame sections apart.
5.
Turn the loosened knurled-thumb screws into the mattress base frame again so that
they are not lost.
The storage aid connects the two chassis and supports the two halves of the mattress base
frame. It also offers holders for the safety side bars and the patient lifting pole. Proceed as
follows:
• Screw the two parts of the storage aid onto the connection pieces of a chassis.
• All knurled-thumb screws of the storage aid must point downwards. The holders
for the mattress base frame must point upwards; the basket for the safety side
bars must face inwards and the holder for the patient lifting pole must face out-
wards. Use the knurled-thumb screws from the mattress base.
• Screw on the second chassis.
• First place the other half of the mattress base frame (backrest) on the short holders so
that the head end (lifting pole sleeves) points downwards. The mattress handle [10]
points inwards.
• Then place one half of the mattress base frame (foot half) on the longer holder so that
the foot end points downwards. The mattress handle points inwards.
Dismantling the Care Bed
Part B: Operator and Technical Personnel 47