burmeier Dali - Dismantling the Care Bed

9 Dismantling the Care Bed
9.1 Dismantling the care bed
Proceed as follows to dismantle the care bed:
1.
Apply the brakes to the castors on the bed.
2.
Remove the patient lifting pole.
3.
Remove all the safety side bars, one after the other.
•
Press the release button [a] in the safety side guide downwards with your finger
and lift the bar out.
•
Repeat this step for all bars.
4. Move the bed to the lowest position.
5. Unplug the switch mode power supply unit (for standard, Low-entry and wash)/ or (for
econ, low-econ, low-entry-econ) unplug the power plug from the socket.
6. In the case of standard, Low-entry and wash: Disconnect the power cable plug from the
socket:
• To do so, pull the pull-out prevention device on the socket upwards to release the
retaining element.
• Unplug the 6-pole plug from the socket.
• Close off the connection socket with the attached blind plug.
• Press the pull-out prevention device from above onto the socket as far as it will
go.
46 Part B: Operator and Technical Personnel