YAK 130
BVM ©2016 10 Mar. 23, 2016
Use medium Zap-A-Gap to glue these lap
seams together if needed. They might have
gotten jarred during packing and shipping.
Inspect the Inlet Cowl Lip; use a Dremel rotary
rod grinder (#RF6C) to remove excess resin
globs from the fuselage inlet lip that might
interfere with the inlet duct fit.
Following the trial fitting of the Inlet Duct, use an #80 grit sanding block to straighten the
aft edge of the inlet lips if needed.
To Next Page
Loading...
