BVM Yak 130 - Page 22

YAK 130
BVM ©2016 21 Mar. 23, 2016
 Plug the (4) wire bundle into the #4 circuit
board.
 Disconnect the #2 circuit board and route
the wires as in the previous step.
 Continue routing the #2 wires through the
next former as pointed to by the pencil in
the photo.
 Reconnect the #2 wires into the #2 circuit
board.
 Again, disconnect the #4 wire bundle and
route it through the same place as the #2
wires. Then reconnect to their circuit board.