BWT MINISTIL P-21 - Disassembly and Decommissioning; Disassembly the Connection Head; Disassembly the Plug-in Connection Angle; Disassembly the Screwable Connection Angle

EN
86
12. Disassembly and decommissioning
When a cartridge is exhausted, it should always be put out
of operation and replaced.
CAUTION:
˳Öãö³þóöÃĂþã½½ďÖď³ÆÝþóòĐĐþ³òïÆï³
˳V³Üãď³þóÜÆÝöïÖĂ¾½òãÜþóöã©Ô³þ
Vent the device: To remove any air in the cartridge, open the
ventilation valve (1).
12.1 Disassembly the connection head
open
˳:ã©Ôþó¯ïþ³ò¨ĖþĂòÝÆݾþóÖã©ÔÆݾö©ò³Đ(1) a quarter
turn to the left.
˳bó¯ïþ³òÆöÆÝþó“open” position
˳V³Üãď³þó¯ïþ³ò
˳ÖĐĖöÖĖþó¯ïþ³òĐÆþÃþóÝãěěÖ³ïãÆÝþÆݾ
downwards so that no water can flow into the casing.
Assembly of the connection head when exchanging the
cartridge see Part. 6.3.
12.2 Disassembly the plug-in connection angle
open
˳fÝÖã©Ôþóò³þÆÝÆݾïÖþ³¨ĖþĂòÝÆݾþóÖã©ÔÆݾö©ò³Đ(1)
a quarter turn to the left.
2
3
˳V³Üãď³þóò³þÆÝÆݾïÖþ³(2) and connection fitting (3).
For instructions on mounting the connection fittings when
replacing the cartridge, see Part 6.4.
12.3 Disassembly the screwable connection
angle
˳ò³½ĂÖÖĖĂÝö©ò³Đþó©ãÝݳ©þÆãÝݾֳ
˳öö³Ü¨ÖĖã½þó©ãÝݳ©þÆãÝݾֳĐóÝ³ĕ©ÃݾÆݾ
the cartridge, see Part. 6.5.