To Next PageTo Next Page
Need help?Do you have a question about the Camus Hydronics Avenger Series and is the answer not in the manual?
Manual review before installation is recommended for proper understanding of the appliance.
Details the step-by-step process from power on to burner ignition and operation.
Specifies minimum safe distances from combustible materials for installation.
Guidelines for selecting an appropriate installation location and procedure.
Provides overall guidance for venting the appliance, including material and code compliance.
Specifies required clearances for vent terminals from building features and surroundings.
Details requirements for indoor venting installations using common or dedicated chimneys.
Covers requirements and guidelines for sidewall venting configurations.
Outlines requirements for safe and proper gas supply connection to the appliance.
Explains the operation and function of the air/gas ratio control valve for combustion.
Procedure for verifying the incoming gas supply pressure meets specifications.
Details how to measure and adjust air and gas differential pressures for proper combustion.
Provides methods and recommendations for preventing freezing in the appliance and system.
Explains the function and installation of the Low Water Cutoff safety device.
Guidance on selecting the appropriate circulating pump for optimal performance.
Details power requirements and wiring instructions for the appliance.
Describes the function of the low air pressure switch for combustion proofing.
Explains the high limit Aquastat control for maximum discharge water temperature.
Lists and explains various error codes displayed by the appliance controller.
Overview of the SOLA controller, its functions and display.
Guides users through the appliance configuration menu for various settings.
Configuration details for setting up lead lag operation between multiple boilers.
Pre-startup checks to ensure correct water, gas, and electrical connections.
Procedure for adjusting the gas valve for optimal combustion settings.
Final steps for placing the appliance into service after startup.
Guidance on inspecting the venting system for tightness, corrosion, and blockages.
Instructions for removing, cleaning, and inspecting the appliance burner.
Recommendations and procedures for protecting the appliance from freezing.
Final checks before starting the boiler, including gas, water, and electrical connections.
Recommendations for installing heating boilers, including piping and system requirements.
A list of parts with corresponding figures and model applicability.
General terms and conditions of the limited warranty for the appliance.
Specific warranty coverage and duration for the heat exchanger component.
Instructions on how to submit a warranty claim to Camus Hydronics.
General| Fuel Type | Natural Gas or Propane |
|---|---|
| Construction | Stainless Steel Heat Exchanger |
| Thermal Efficiency | Up to 95% |
| Ignition | Electronic |
| Efficiency | Up to 95% |
| Operating Pressure | 30 psi |
| Vent Diameter | 2" or 3" |
| Dimensions | Varies by model |
| Weight | Varies by model |
