Cannot
edit
my
recordings
or
add
recordings
to
the
disc
with
the
DVD
device.
- It may not be possible to edit
or
add
recordings with
an
external
DVD
recorder on a disc recorded with this
camcorder.
Memory
Card Operation
Memory
card
cannot
be
inserted.
- Memory card is not facing the correct
direction. Turn the memory card over
and reinsert it
(OJ 28).
Cannot
record
on
the
memory
card.
- Memory card is full. Erase still images
(OJ
55)
to
free some space
or
replace
the memory card.
- Memory card was not initialized.
Initialize the memory card
(CD
59).
- The folder and file numbers have
reached their maximum value. Set
[FILE NOS.]
to
[RESET]
(CD
68) and
insert a new memory card.
- The write-protect switch on
an
SO
or
SDHC memory card is set
to
prevent
accidental erasure. Change the position
of
the write-protect switch.
Memory
card
cannot
be
played
back.
- Set the camcorder
to
e_,~.
mode
(CD
53).
Image
cannot
be
erased.
- Image is protected. Cancel the
protection
(CD
58).
- The write-protect switch on
an
SO
or
SDHC memory card is set
to
prevent
accidental erasure. Change the position
of
the write-protect switch.
m
appears
in red.
- A memory card error occurred. Turn off
the camcorder. Remove and reinsert
the memory card. Initialize the memory
card
(CD
59)
if the icon still appears
in
red.
List
of
Messages
(in
alphabetical
order)
CANNOT ENTER THE
~
STANDBY
MODE
NOW
- The camcorder cannot enter the Quick
Start standby mode
(CD
32)
while the
disc is being recognized after it was
inserted or if the remaining battery
charge is too low.
CANNOT PLAY
BACK
- The disc is dirty or you attempted to
play back a disc type not supported by
this camcorder (not DVD-R/RW) or a
disc that is dirty or scratched.
- This message can also appear if
condensation has formed. Wait until the
camcorder dries completely before
resuming use
(CD
79).
CANNOT READ THE DISC .
CHECK
THE DISC
- Disc could not be read.
Try
cleaning it
or
replace the disc
(CD
77).
- This message can also appear if the
camcorder has exceeded its
operational temperature. Turn off the
camcorder and let it cool down before
resuming use.
- This message can also appear if
condensation has formed. Wait until the
camcorder dries completely before
resuming use
(CD
79).
- The disc may not be loaded correctly.
Try
removing the disc and reinserting it
(CD
26).
• CANNOT RECORD
• CANNOT RECORD
CHECK
THE DISC
- There is a problem with the disc.
Replace the disc
(CD
26).
- This message can also appear if
condensation has formed. Wait until the
camcorder dries completely before
resuming use
(CD
79).
-
The
disc's
recording
surface
may
be
dirty or scratched.
- This message may appear when the
camcorder is repeatedly subject to
vibration.
Additional
Information
•
73
To Next Page
Loading...
