Troubleshooting Guide
Shooting
No images can be shot or recorded.
• The card is not properly inserted (p.29).
• If the card is full, replace the card or delete unnecessary images to
make room
(p.29, 144).
• If you try to focus
in
the One-Shot AF mode while the focus
confirmation light
<.
>
in
the viewfinder blinks, a picture cannot be
taken. Press the shutter button halfway again to focus, or focus
manually (p.35, 88).
The LCD monitor does not display a clear image.
• If dust is adhering to the LCD monitor, wipe with a lens cloth or soft
cloth.
~
In low or high temperatures, the LCD monitor display may seem slow
or
it might look black. It will return to normal at room temperature.
The image is out of focus.
• Set the lens focus mode switch to <AF> (p.31).
•
To
prevent camera shake, hold the camera still and press the shutter
button gently (p.34, 35).
• If the lens has an Image Stabilizer, set the IS switch to
<ON>.
The card cannot be used.
• If a card error message is displayed, see page 30 or 201.
The
camera
makes
a
noise
when
it
is
shaken.
• The built-in flash's pop-up mechanism moves slightly. This is normal.
199
I
To Next Page
Loading...
