Printing procedure
Important
• Always specify the same type and size of paper in the printer menu and printer driver .
If the type and size do not match, an error message is displayed and the printing quality may be
af fected, or printing may not be possible.
• Papr Size Mismatch (→P .785)
• Papr T ype Mismatch (→P .785)
• Paper Mismatch (→P .785)
9. Send the print job.
• Printing from Windows (→P .92)
• Printing from Mac OS X (→P .93)
• Printing from Mac OS 9 (→P .95)
Start printing.
Note
• Y ou can skip steps 6 and 7 if a barcode has been printed on the roll paper and you have activated
automatic detection of the remaining roll. The paper type and amount of paper left are automatically
detected. The barcode will automatically be cut of f after it has been read.
• Y ou can skip step 7 if you have deactivated automatic detection of the remaining roll paper .
• If you have deactivated width detection, you will need to enter the roll width after choosing the paper
type in step 6. ( → P .54)
• If you select a type of paper for which width detection is Off when detection of the remaining roll paper is
also Off , you will need to advance the paper manually to the starting position for printing. ( → P .127)
• For details on supported sizes and types of rolls, see “Paper Sizes” or the Paper Reference Guide .
( → P .1 14) ( → P .109)
• When printing on rolls after printing on sheets, if the lit paper selection lamp does not switch from the
Cut Sheet lamp to the Roll Media lamp , press the Feeder Selection button.
Important
• After changing rolls, clean the Platen . ( → P .742 )
88 Basic Printing W orkow
To Next Page
Loading...
Need help?
General