Messages regarding paper
Cannot feed paper .
Cause Corrective Action
Reload the paper correctly and advance it again.
( → P .121)
Paper came out of the feed path during feeding.
If the message is displayed when paper is not being
advanced, contact your Canon dealer for assistance.
Cannot cut this paper .
Cause Corrective Action
There are sheets left on the Ejection Guide . Lift the Release Lever and remove the paper .
There is a foreign object by the Output T ray ,
obstructing the Cutter Unit .
Lift the Release Lever and remove the foreign object.
Y ou are not using the printer under the recommended
environmental conditions for the paper .
Use the printer only where the recommended
environmental conditions for the paper are met.
Note that various environmental conditions are
recommended for various types of paper . For details
on the recommended environmental conditions for
paper , see Paper Reference Guide ."
( → P .109)
Y ou are using paper that is not compatible with
automatic cutting.
Specify Manual as the method for cutting rolls and
cut the roll manually .
( → P .139)
For details on automatic cutting compatibility , see the
Paper Reference Guide .
( → P .109)
The Cutter Unit stops in the middle of cutting. Move the Carriage to the left, remove the paper ,
and return the Carriage to the right. If cutting is not
possible using the Cutter Unit , specify Manual as the
method for cutting rolls and cut the roll manually .
( → P .131)
( → P .139)
The Cutter Unit is not installed. Install the Cutter Unit .
( → P .728)
In other cases, the Cutter Unit may be damaged. Contact your Canon dealer for assistance.
Error Message 791
To Next Page
Loading...
Need help?
General