Canon imagePROGRAF iPF8000S - Activating Appletalk on the Printer

Network Setting (Macintosh)
Conguring the Destination for AppleT alk Network
(Macintosh)
T o print over an AppleT alk network, activate the AppleT alk protocol and congure the destination as follows.
Activating AppleT alk on the printer
Important
• By factory default, the AppleT alk protocol is disabled on the printer .
1. Press the Menu button to display MAIN MENU .
2. Press ▲ or ▼ to select Interface Setup , and then press the ► button.
3. Press ▲ or ▼ to select AppleT alk , and then press the ► button.
4. Press ▲ or ▼ to select On , and then press the OK button.
5. Press the Online button to bring the printer online.
If any of the settings is changed, a message for conrmation is displayed. In this case, press
the OK button.
Important
• Be sure to complete step 5. This will activate the values you have entered.
Note
• By using RemoteUI , you can also specify the object name used by AppleT alk, as well as the printer
zone name.
For details on RemoteUI , see “Using RemoteUI”. (→P .585)
Network Setting 61 1