Control Panel
Specifying numerical values
Follow the steps below to enter numbers for items such as network settings.
1. Press ▲ or ▼ to select Interface Setup , and then press the ► button.
2. Press ▲ or ▼ to select TCP/IP , and then press the ► button.
3. Press ▲ or ▼ to select IP Setting , and then press the ► button.
4. Press ▲ or ▼ to select IP Address , and then press the ► button.
5. Press ◄ or ► to move the cursor (_) to each eld for entering numbers.
6. Press the ▲ or ▼ button to enter the value.
Note
• Hold down ▲ or ▼ to increase or decrease the value continuously .
• Make sure the IP address you enter for the printer is not the same as any computer IP address
in your network.
7. Repeat steps 5-6 to enter the IP address assigned to the printer .
8. Press the Online button to bring the printer online.
If any settings are changed, a conrmation message is displayed. In this case, press the OK
button.
Executing menu commands
Follow the steps below to execute menu commands.
1. Press ▲ or ▼ to select a menu, and then press the ► button.
Repeat these steps until the desired menu options are displayed.
2. Press ▲ or ▼ to select the action to execute, and then press the OK button.
After two seconds, the menu command is executed. After commands are executed, the printer
commonly reverts to the state before the menu operation, either online or of ine.
Printer Parts 41
To Next Page
Loading...
Need help?
General