Handling rolls
Loading the Roll in the Printer
Follow these steps to load rolls in the printer .
Note
• Remove any loaded paper that will not be used.
• Roll ( → P .128) ( → P .129)
• Sheet ( → P .152)
• If the Platen is dirty , clean inside the T op Cover . ( → P .742)
1. Open the T op Cover and lift the Ejection Guide .
2. Pull out the roll paper evenly on both ends, insert the roll paper in the Paper Feed Slot (a), and
advance the roll paper until the roll paper touches the Paper Retainer .
After the paper reaches the Paper Retainer , it is automatically advanced over the Platen .
Handling Paper 121
To Next Page
Loading...
