Other Messages
Other Messages
GARO Wxxxx (x represents a number)
Cause Corrective Action
T ry printing again, using the correct printer driver .There is a problem with the print job.
It is also possible to continue printing in this state.
However , you may not be able to obtain the desired
printing results.
ERROR Exxx-xxxx (x represents a letter or number)
In the following situations, turn of f the printer and wait at least three seconds before restoring power .
If the message is still displayed, write down the error code and message, turn of f the printer , and contact your
Canon dealer for assistance.
• “ERROR” is displayed, followed by the error code and Call for service. .
Hardware error . xxxxxxxx-xxxx (x represents a letter or
number)
In the following situations, turn of f the printer and wait at least three seconds before restoring power . However ,
keep the printer of f and remove the roll if the last portion of roll paper was used during a print job and paper
could not be advanced because the trailing edge is taped to the roll. If tape and the Belt Stopper have not
been removed from inside the T op Cover , turn of f the printer , open the T op Cover , and remove the tape
and Belt Stopper before restoring power .
If the message is still displayed, write down the error code and message, turn of f the printer , and contact your
Canon dealer for assistance.
• The error message is displayed with the following instructions: T urn off printer , wait, then turn on
again. .
T op cover is open.
Cause Corrective Action
Open the T op Cover fully , remove any foreign objects,
and close the T op Cover again.
The printer has detected that the T op Cover is open.
If the error occurs again, turn of f the printer and wait
a while before restoring power .
Error Message 803
To Next Page
Loading...
Need help?
General