Handling rolls
Handling rolls
Loading Rolls on the Roll Holder
When printing on rolls, attach the Roll Holder to the roll.
Important
• Cut the edge of the roll paper if it is uneven, dirty , or has tape residue. Otherwise, it may cause feeding
problems and af fect the printing quality . Be careful not to cut through any barcodes printed on the roll.
• Wind up the roll so that the edge is even across the roll. This may cause feeding problems.
Caution
• Set the roll on a table or other at surface so that it does not roll or fall. Rolls are heavy , and dropping a
roll may cause injury .
Note
• Printed rolls will not work correctly . Cut away the printed portion before loading the roll.
• For details on supported sizes and types of rolls, see “Paper Sizes” or the Paper Reference Guide .
( → P .1 14) ( → P .109)
• After pressing the Load/Eject button, you can refer to instructions on the Display Screen as you load
the paper .
Handling Paper 1 17
To Next Page
Loading...
Need help?
General