Handling rolls
1. Lift the Holder Stopper lever (a) from the shaft side to unlock it. Holding the Holder Stopper at
the position indicated (b), remove it from the Roll Holder .
2. With the edge of the roll paper facing forward as shown, insert the roll in the Roll Holder from the
left. Insert the roll rmly until it touches the ange (a) of the Roll Holder .
Important
• When setting a roll, be careful to avoid hitting the roll holder ange hard with the roll. This may
damage the Roll Holder .
1 18 Handling Paper
To Next Page
Loading...
Need help?
General