Control Panel
Interface Setup
Setting Item Description, Instructions
EOP T imer Specify the timeout period before cancellation of print
jobs that cannot be received by the printer .
IP Mode Choose whether the printer IP address is congured
automatically or a static IP address is entered
manually .
DHCP
BOOTP
Protocol
RARP
Specify the protocol used to congure the IP address
automatically .
IP Address
Subnet Mask
TCP/IP
IP Setting
Default G/W
Specify the printer network information when using
a static IP address.
Enter the IP address assigned to the printer , as well
as the network subnet mask and default gateway .
NetW are Specify the NetW are protocol. T o apply your
changes, choose Register Setting .
Frame T ype Specify the frame type to use.
NetW are
Print Service Choose the print service.
AppleT alk Specify whether to use the AppleT alk protocol. T o
apply your changes, choose Register Setting .
Auto Detect Specify the communication method. T o apply your
changes, choose Register Setting .
Choose On for automatic conguration of the LAN
communication protocol. Choose Off to apply
Comm.Mode and Ethernet T ype settings.
Comm.Mode Choose the LAN communication method.
Ethernet T ype Choose the LAN transfer rate.
Spanning T ree Choose whether spanning-tree packets are
supported over the LAN.
Ethernet Driver
MAC Address Displays the MAC address.
Return Defaults Execute? is displayed if you press the ▼ button.
Choose OK to restore the network settings to the
default values.
60 Printer Parts
To Next Page
Loading...
Need help?
General