Canon imagePROGRAF iPF8000S - Page 475

Other useful settings
Cutting Roll Paper After Printing (W indows)
This topic describes how to cut roll paper automatically (using the auto cut function) after printing, as well as
how to print a cut line to cut the paper manually .
Note
• Auto cut function is activated on the printer by factory default and when the printer driver is installed.
Follow the steps below to reactivate the function after it is disabled, or to change the setting for printing a
cut line instead.
1. Choose Print in the application menu.
2. Select the printer in the dialog box, and then display the printer driver dialog box. ( → P .482)
3. Click the Page Setup tab to display the Page Setup sheet.
4. Click Roll Paper in the L Paper Source list.
5. Click N Auto Cut to display the Automatic Cutting Settings dialog box.
6. T o enable automatic cutting, click Y es in the A Automatic Cutting list. If you prefer to cut the
paper later yourself, click Print Cut Guideline .
7. Click OK to close the Automatic Cutting Settings dialog box.
8. Conrm the print settings and print as desired.
Note
• For tips on conrming print settings, see “Conrming Print Settings (Windows)”. (→P .476)
Roll paper will be automatically cut after printing.
Enhanced Printing Options 459