Canon imagePROGRAF iPF8000S User Manual

Network Setting
Conguring the IP Address on the Printer
Y ou must congure the printer ’ s IP address before using the printer in a TCP/IP network.
The printer ’ s IP address is congured automatically when you install the printer driver following the instructions
in the Quick Start Guide .
Congure the IP address by using imagePROGRAF Device Setup Utility , the printer Control Panel , or ARP or
PING commands, if the IP address is changed, or if you change the printer connection mode to a network
connection. For details on conguring the IP address, refer to the following topics.
• Conguring the IP Address Using imagePROGRAF Device Setup Utility (→P .582)
• Conguring the IP Address Using the Printer Control Panel (→P .583)
• Conguring the IP Address Using ARP and PING Commands (→P .584)
Important
• If you use a DHCP server for automatic assignment of the printer ’ s IP address, printing may no longer
be possible after the printer is turned of f and on. This is because an IP address dif ferent from before
has been assigned. Thus, when using DHCP server functions, consult your network administrator and
congure the settings in one of the following ways.
• Congure the setting for dynamic DNS updating
In RemoteUI , activate the setting Enable DNS Dynamic Update . ( → P .586)
• Congure the setting for assignment of the same IP address each time the printer starts up
Note
• W e recommend conguring the printer ’ s IP address even if you will use the printer in networks other
than TCP/IP networks. Conguring the printer ’ s IP address enables you to use RemoteUI to congure
the network settings and manage the printer with a web browser .
For details on RemoteUI , see “Using RemoteUI”. (→P .585)
Network Setting 581

Canon imagePROGRAF iPF8000S Specifications

General

Brand	Canon
Model	imagePROGRAF iPF8000S
Category	Printer
Language	English