Network Setting (Windows)
Specifying the frame type using the printer Control Panel
1. Press the Menu button to display MAIN MENU .
2. Press ▲ or ▼ to select Interface Setup , and then press the ► button.
3. Press ▲ or ▼ to select NetW are , and then press the ► button.
4. Press ▲ or ▼ to select NetW are , and then press the ► button.
5. Press ▲ or ▼ to select On , and then press the OK button.
Return to the NetW are menu.
6. Press ▲ or ▼ to select Frame T ype , and then press the ► button.
7. Press ▲ or ▼ to select the frame type to use, and then press the OK button.
Return to the NetW are menu.
8. Press ▲ or ▼ to select Print Service , and then press the ► button.
9. Press ▲ or ▼ to select the desired print service, and then press the OK button.
Return to the NetW are menu.
10. Press the Online button to bring the printer online.
If any of the settings is changed, a message for conrmation is displayed. In this case, press
the OK button.
Important
• Be sure to complete step 10. This will activate the values you have entered.
Note
• If an error message is displayed, check the settings and correct any invalid values.
• T o cancel the setup process, hold down the Stop button for a second or more.
Network Setting 601
To Next Page
Loading...
Need help?
General