Ink T anks
3. Press the OK button and insert the Ink T ank into the holder facing as shown in the gure, with
the ink holes down.
Important
• Ink T ank cannot be loaded in the holder if the color or orientation is wrong.
If the Ink T ank does not t in the holder , do not force it into the holder . Make sure the color of the
Ink T ank Lock Lever matches the color of the Ink T ank , and check the orientation of the Ink T ank
before reloading it.
4. Lift the Ink T ank Lock Lever until it stops, and then push it down until it clicks into place.
5. Make sure the Ink Lamp is lit in red.
Note
• If the Ink Lamp is not lit in red, reload the ink.
• Ink Lamp ashes when there is little ink left.
Maintenance 713
To Next Page
Loading...
Need help?
General