Printing procedure
8. Start printing.
• Printing from Windows (→P .149)
• Printing from Mac OS X (→P .150)
• Printing from Mac OS 9 (→P .152)
Note
• Y ou can skip steps 5 and 6 if a barcode has been printed on the roll paper and you have activated
automatic detection of the remaining roll. The paper type and amount of paper left are automatically
detected. The barcode will automatically be cut of f after it has been read.
• Y ou can skip step 6 if you have deactivated automatic detection of the remaining roll paper .
• If you have deactivated width detection, you will need to enter the roll width after choosing the paper
type in step 5. ( → P .48)
• For details on supported sizes and types of rolls, see Paper Sizes (→P .173) or the Paper Reference
Guide . ( → P .167)
• When printing on rolls after printing on sheets, if the lit paper selection lamp does not switch from the
Cut Sheet lamp to the Roll Media lamp , press the Feeder Selection button.
Important
• After changing rolls, clean the Platen . ( → P .718)
Basic Printing W orkow 143
To Next Page
Loading...
