Canon LBP7200Cdn - Paper Handling System Components

Chapter 3
3-22
F-3-96
2) Remove the RD sensor unit [1].
F-3-97
3.4 PICKUP/FEEDING/DELIVERY SYSTEM
3.4.1 Pickup Motor
3.4.1.1 Pre-procedure for removing pick-up motor
0021-3996
1) Remove the right cover.(page 3-3)Reference[Removing right cover]
2) Remove the upper rear cover (left).(page 3-1)
Reference[Removing up-
per rear cover (left)]
3) Remove the upper cover.(page 3-5)
Reference[Removing upper cover]
4) Remove the right frame cover.(page 3-3)
Reference[Removing right
frame cover]
3.4.1.2 Removing pick-up motor
0021-3999
1) Remove 7 connectors [1], and then remove the cable [2] from the cable
guide [3].
F-3-98
2) Remove the cable guide [1] in the arrow direction.
- 1 boss [2]
F-3-99
3) Remove the pick-up motor [1] in the arrow direction.
- 2 screws [2]
F-3-100
CAUTION:
When you pass the cable of the RD sensor unit to the hole on the side
plate, be careful not to damage the cable.
[1]
[1]
[2] [3]
[1]
[1]
[1][2] [3]
[1]
[2]
[1][2]