Canon LBP7200Cdn - Fixing Motor; Pre-Procedure for Removing Fixing Motor; Removing Fixing Motor

Chapter 3
3-32
F-3-135
3.5.4 Fixing Motor
3.5.4.1 Pre-procedure for removing fixing motor
0021-4098
1) Remove the right cover.(page 3-3)Reference[Removing right cover]
2) Remove the upper rear cover (left).(page 3-1)
Reference[Removing up-
per rear cover (left)]
3) Remove the upper cover.(page 3-5)
Reference[Removing upper cover]
4) Remove the right frame cover.(page 3-3)
Reference[Removing right
frame cover]
3.5.4.2 Removing fixing motor
0021-4099
1) Remove the main controller PCB [1].
- 1 flat cable [2]
- 4 screws [3]
F-3-136
2) Remove the sheet metal [1] of the main controller PCB.
- 7 screws [2]
F-3-137
3) Remove three connectors [1], and remove the cable [2] from the cable
guide [3].
F-3-138
4) Remove the cable guide [1].
F-3-139
5) Remove the sub power supply PCB unit [1].
- 2 connectors [2]
CAUTION:
Do not touch the surface of the fixing pressure roller.