Canon LBP7200Cdn - Fixing Pressure Roller; Pre-Procedure for Removing Fixing Pressure Roller; Removing Fixing Pressure Roller

Chapter 3
3-31
F-3-131
5) Remove the cable [1] from the cable guide [2].
F-3-132
6) Remove the cable guide [1].
F-3-133
7) Remove the fixing film unit [1].
F-3-134
3.5.3 Fixing Pressure Roller
3.5.3.1 Pre-procedure for removing fixing pressure roller
0021-4291
1) Remove the right cover.(page 3-3)Reference[Removing right cover]
2) Remove the upper rear cover. (left).(page 3-1)
Reference[Removing up-
per rear cover (left)]
3) Remove the upper cover.(page 3-5)
Reference[Removing upper cover]
4) Remove the rear cover.(page 3-4)
Reference[Removing left cover]
5) Remove the rear cover.(page 3-1)
Reference[Removing rear cover]
6) Remove the lower rear cover.(page 3-1)
Reference[Removing lower rear
cover]
7) Remove the rear cover lib unit.(page 3-1)
Reference[Removing rear cov-
er lib unit]
8) Remove duplex reverse drive unit.(page 3-9)
Reference[Removing du-
plex reverse drive unit]
9) Remove fixing unit.(page 3-29)
Reference[Removing fixing unit]
10) Remove fixing film unit.(page 3-30)
Reference[Removing fixing film
unit]
3.5.3.2 Removing fixing pressure roller
0021-4292
1) Remove the fixing pressure roller [1].
- 2 bushings [2]
- 1 gear [3]
CAUTION:
When you disassemble or assemble the fixing film unit, do not touch or
damage the fixing film [1].
[1]
[2]
[3] [4]
[5]
CAUTION:
Since the spring is very small, you should be careful not to lose it when
removing it.