[C-06] Uninstalling the e-Manual
The process of removing the e-Manual to restore the computer to the same state as before the e-Manual was installed is
referred to as uninstallation. To uninstall the e-Manual, perform the following procedure.
IMPORTANT
Uninstallation by a user with administrative rights
A user without administrative rights cannot perform the uninstallation. To perform the
uninstallation, be sure to log on as a user with administrative rights.
Contact your system administrator if you are not sure about your administrative rights.
Insert the supplied CD-ROM "User Software" into the CD-ROM drive of your computer.
If the CD-ROM is already in the drive, eject the disk and reinsert it into the drive.
ĺ CD-ROM Setup appears.
It may take time to display CD-ROM Setup depending on your environment.
NOTE
If CD-ROM Setup does not appear
Display it using the following procedure.
(The CD-ROM drive name is indicated as "D:" in this manual. The CD-ROM drive name may
differ depending on the computer you are using.)
Windows XP and Server 2003
1. From the [Start] menu, select [Run].
2. Enter "D:\English\MInst.exe", and then click [OK].
Windows Vista and Server 2008
1. Enter "D:\English\MInst.exe" in [Start Search] under the [Start]
menu.
2. Press the [ENTER] key on the keyboard.
If the [AutoPlay] dialog box appears (Windows Vista and Server 2008)
Click [Run AUTORUN.EXE].
If the [User Account Control] dialog box appears (Windows Vista and Server 2008)
Click [Continue].
Click [Additional Software Programs].
㻠㻜㻌㻛㻌㻣㻜㻡
To Next Page