CALIBRATION and SETUP, Cont.
OPERATIONAL SETUP, Cont.
EUROPEAN DATE
The display will show europeurop, the prompt to enable or disable the European Date format and
display the current setting. This feature, when enabled will print the date on tickets in the
European (International) format of day/month/year (DD/MM/YYYY). If disabled, the date on
the tickets will print in the month/day/year (MM/DD/YYYY) format. To change the setting,
press the YES/1 key to enable or the NO/0 key to disable, then press the ENTER key to save
the setting and proceed to the next prompt.
MANUAL COUNT OVERRIDE
The display will show n cntn cnt, the prompt to enable or disable the Manual Count Override and
display the current setting. This feature, when enabled will allow a counting operation to
continue while the Insufficient Sample annunciator is illuminated. If disabled, the counting
operation can not be contiuned until additonal sample pieces are placed on the scale
platform. To change the setting, press the YES/1 key to enable or the NO/0 key to disable,
then press the ENTER key to save the setting and proceed to the next prompt.
PRINTER OUTPUT
The display will show prntrprntr, the prompt to enable or disable the Printer output and display
the current setting. To change the setting, press the YES/1 key to enable or the NO/0 key to
disable, then press the ENTER key to save the setting and proceed to the next prompt.
If printer output is enabled, additional setup prompts (TICKET FORMAT and PRINT
BARCODE) will be displayed. If printer output is disabled, the setup procedure will
advance to the UNITS OF MEASUREMENT prompt.
TICKET FORMAT
If Printer Output was enabled, then the display will show ticfrticfr, the prompt to select the
format for ticket printing and display the current setting. The available formats are:
1 = Vertical Printing (The printed line is parallel with the print head)
2 = Horizontal Printing (The printed line is at right angle to the print head)
3 = Generic Text Printer (ASCII text ouptut with CR/LF control codes only)
To change the setting, on the numeric keypad press the YES/1 key to select the vertical
format, the 2 key to select the horizontal format or the 3 key to select the Generic Text
Printer. Press the ENTER key to save the setting and proceed to the next prompt.
NOTE: The maximum number of digits in an ID number is dependent upon the Ticket Format
selected. When using format 1, the maximum is 10 digits. When using format 2, the maximum
length of an ID number is 12 digits.
PRINT BARCODE
If Printer Output was enabled, and Ticket Format 1 or 2 was chosen, then the display will
show barcobarco, the prompt to enable or disable printing barcode on the ticket and display the
current setting. To change the setting, press the YES/1 key to enable or the NO/0 key to
disable, then press the ENTER key to save the setting and proceed to the next prompt.
NOTE: Barcode printing is available only when Ticket Format 1 or 2 have been selected.
Ticket Format 3 (Generic Text Printer) does not support bardocde.
27
To Next Page
Loading...
