7
Models C708/C709/C716/C717
Introduction
Model C717 Specifications
Freezing Cylinder
Two, 3.4 quart (3.2 liter)
Mix Hopper
Two, 20 quart (18.9 liter)
Beater Motor
Two, 1.5 hp
Refrigeration Unit
Two, approximately 9,500 btu/hr compressors
Refrigerant R404A.
Electrical
Electrical
Maximum
Fuse Size
Minimum
Circuit
Ampacity
Left Right Left Right
208--230/60/1 Air
30 30 24 21
208--230/60/3 Air 20 15 16 13
208--230/60/3 Water 15 15 13 13
220--240/50/1 Air 25 20 20 17
380--415/50/3N~Air 12 10 10 7
This unit may be manufactured in other electrical
characteristics. Refer to the local Taylor Distributor
for availability. (For exact electrical information,
always refer to the data label of the unit.)
Air Cooled
Clearance: A minimum of 3” (76 mm) is required
around all sides. Install the deflector provided to
prevent recirculation of warm air.
Water Cooled
Water inlet and drain connections under the side of
the base, 1/2” FPT.
Dimensions
Width: 25-7/16” (646 mm)
Height: 60” (1524 mm)
Depth: 36-3/16 (919 mm)
Floor Clearance*: 4-3/4 (121 mm)
*Mounted on standard casters
Approximate Weights
Net: 728 lbs. (330 kgs)
Crated: 766 lbs. (348 kgs)
Volume: 66.5 cu. ft. (1.88 cu. m.)
Figure 4
To Next Page
Loading...
